SProject - Ten Pad, Low Power, Launcher - Randy Regan.
Project - Build a 10 pad, low power, launcher out of PVC piping to support large events like the Boy Scout launch.
Using 2" PVC, added end pieces.
Now have 4 legs and one 10' beam. Finished leg section.
Insides needed to be sanded to fit better. Legs are set at an angle.
Holes are drilled in deflector shields. Rods will be held in place by two wire nuts.
Center beam is cut in the middle.
Center supported is added and then later cut.
Finished launcher, 10 holes have been drilled. Launch rod mounting. Other holes could be added to get more angles.
Launch rod mounted on center beam. Launcher with one of the ten rods.
Launcher broken down for transport.
